Error Messages In Operation - ratiotec T 100 Bedienungsanleitung

In addition to these error messages that may occur when the banknote counter system starts, there are
numerous messages to indicate a suspected counterfeit banknote. See the following table:

Error messages in operation:

Error message
Magnetic
feature fail
Slant notes
Remove all
Chained notes
Remove all
Double notes
Remove all
Incomplete notes
Remove all
UV error
IR error
Width error
Cause
The banknote fed is seriously dama-
ged, dirty or is suspect of being coun-
terfeit.
The banknote counter has drawn in the
banknote at an angle.
Several notes stuck together have
been drawn in and have been identi-
fied as one single note.
More than one note was drawn in at
the same time.
An incomplete banknote was drawn in.
The banknote fed is seriously dama-
ged, dirty or is suspect of being coun-
terfeit.
The banknote fed is seriously dama-
ged, dirty or is suspect of being coun-
terfeit.
The banknote fed is seriously dama-
ged, dirty or is suspect of being coun-
terfeit.
Action
Remove the last ejected banknote.
Check whether the banknote is genuine
and place the banknote in the middle
of the feeder. Continue the counting by
pressing the START button.
Remove all the banknotes from the
stacker and restart the counting pro-
cedure.
Remove all the banknotes from the
stacker and restart the counting pro-
cedure.
Remove all the banknotes from the
stacker and restart the counting pro-
cedure.
Remove all the banknotes from the
stacker and restart the counting pro-
cedure.
Remove the last ejected banknote.
Check whether the banknote is genu-
ine and continue the counting proce-
dure by pressing the START button.
Remove the last ejected banknote.
Check whether the banknote is genu-
ine and continue the counting proce-
dure by pressing the START button.
Remove the last ejected banknote.
Check whether the banknote is genu-
ine and continue the counting proce-
dure by pressing the START button.
11