ratiotec T 100 Bedienungsanleitung Seite 7

BATCH
The bundle function lets you count an exact number of banknotes as a bundle and this can be set in-
dependent of the counting mode. The function is activated using the BATCH button. After pressing this
button, you can select from a series of predefined values: 100 > 50 > 20 > 10 > 5 > 0 > 100. If you
want to count off a different number of banknotes, press the +1/+10 button to increase the preset value
in steps. To increase by +1, press the button briefly; to increase by +10, press for an extended period.
The required number of banknotes per bundle will be shown on the display next to the BATCH button.
If the banknote counter is set to a bundle quantity of 20 banknotes, for example, it will stop automa-
tically after this number has been counted. You can delete the bundle quantity and/or deactivate the
BATCH function by pressing the CLEAR button.
Note: The bundle function stops automatically when the stated quantity is reached, even
if the banknote counter is counting a stack of mixed banknotes.
ADD
If the addition function is activated, the display next to the ADD button reads "Yes"; if it is not activated,
the display reads "No".
No:
Once the counting procedure is completed, the result is deleted as soon as you remove all the bank-
notes from the receiver compartment.
Yes:
Once the counting procedure is completed, the counting result is not deleted, even after all the bank-
notes have been removed from the stacker. Each further counting procedure is added to the previous
one. The added value is deleted by pressing on the RESET button.
Note: The addition value is deleted when the addition mode is switched off.
CURR
You can select the currency using this button. The currency currently set is shown on the display next to
the CURR button. The Euro is the supported factory setting.
Model-dependent functions of rapidcount T banknote counters:
rapidcount T 100
Mode
Count:
Describes the item counting mode of the banknote counter. The checking of UV features is not acti-
vated.
UV:
During item counting, the checking of UV features is also activated.
REPORT
When this button is pressed after the counting procedure, the display shows the count result in a clear
form. Repressing the button or starting a new counting procedure brings back the standard display
mode.
7