Error Massages In Operation; Miscellaneous Settings / Hints; Technical Data - ratiotec Rapidcount S 60 Bedienungsanleitung

Error messages in operation
Error message on the display
Eh
EJ
E5 / ES
Ed
F-P
F-F.F-C, F-1, F-2, F-3, F-5, F-6, F-7
FUL

Miscellaneous settings / hints

Should bank notes not be drawn in, you can eli-
minate the error by setting the draw-in mecha-
nism. Lay a bank note in and hold it whilst swit-
ching on the machine. When you feel the pulling
action, the machine is correctly set. If this is not
the case, change the inclination of the banknote
draw-in mechanism by means of the adjusting
1

Technical data

Counting speed
Counting capacity
Feeder / Stacker capacity
Power supply
Energy consumption
Operation temperature
Dimensions
Weight
Measure to be taken
Remove half or incomplete bank note and press RESET in order to con-
tinue counting.
Some bank notes are bonded together. Remove them and put new ones
in. In case of frequent disturbance, turn the adjusting screw for bank-note
feeder in clockwise direction. (See "miscellaneous settings /hints").
Bank note inclined too steeply, press RESET, and lay in again in order to
continue counting.
A bank note with wrong dimension was detected. Remove the bank note,
and lay the stack anew and count again.
Another value as reference note
A fake or suspicious bank note, remove it and press RESET in order to
continue counting.
Bank note tray is full.
screw on the rear side of the machine.
The machine should be cleaned and serviced at
regular intervals for flawless operation. At low
temperatures, wait for 3 minutes before you
start the counting process (minimum conden-
sate water formation on the sensor is possible).
1 Adjusting screw
1,000 bank notes/ minute
0,4 million banknotes/ year
100 / 200
230 / 50Hz
50 W
0°C – 40°C
330 x 265 x 220 mm (L x B x H)
6,5 kg
15