SATA SATAjet 100 B F RP/HVLP Betriebsanleitung Seite 113

<< Operating Instructions SATAjet 100 B F (RP/HVLP), B P >>
• Check spray pattern after cleaning the nozzle set!
• Further tips concerning cleaning can be found at www.sata.com/TV.
9. Maintenance
• Prior to maintenance, disconnect paint spray gun from the com-
pressed air circuit!
• Disassemble and install components very carefully! Exclusively use
included special tools!
9.1. Replacing the nozzle set
and [7-6]
Every SATA nozzle set consists of "paint needle" [7-1], "air cap" [7-2]
and "fluid tip" [7-3] and has been hand-adjusted to provide a perfect
spray pattern. Therefore, always exchange the complete nozzle set. After
installation, please adjust material flow according to chapter 7.2.
9.2. Replacing the air distribution ring
2], [7-3], [8-1], [8-2] [8-3], [7-4], [7-5] und [7-6]
• Remove air distribution ring with SATA extraction tool only.
• Do not apply force to avoid damage of sealing surfaces.
Check sealing surfaces inside the spray gun [8-2] after disassembly,
clean them, if required. Should the sealing surfaces be damaged,
please contact your SATA dealer. Align new air distribution ring with the
help of the 12 o'clock marking [8-3], (pin must be located in the drilling)
and press in with even force. Adjust material flow according to chapter
7.2 after installation.
Note!
Warning! Attention!
Attention!
Note!
[7-1], [7-2], [7-3], [7-4], [7-5]
Steps: [7-1], [7-
EN
VII.9