Temperature Warning; Lamp Replacement; Resetting The Total Lamp Timer - Sharp PG-M15X Serviceanleitung

RESETTING THE TOTAL LAMP TIMER

Maintenance Indicators
Maintenance Indicator
TEMPERATURE The internal
WARNING temperature is
indicator abnormally high.
The indicator flashes in
red.
LAMP The lamp does not
REPLACEMENT illuminate.
indicator
The lamp requires
replacement.
• If the TEMPERATURE WARNING indicator illuminates, follow the above possible solutions and then wait until the projector has cooled down
completely before turning the power back on. (At least 5 minutes.)
• If the power is turned off and then turned on again, as during a brief rest, the LAMP REPLACEMENT indicator may be triggered, preventing
the power from going on. Should this occur, take the power cord out of the wall outlet and put it back in again.
Resetting the lamp timer
Connect the power
1
cord.
Plug the power cord into the AC
socket of the projector.
»
Reset the lamp timer only after replacing the lamp.

LAMP REPLACEMENT

indicator
POWER indicator

TEMPERATURE WARNING

indicator
Condition Problem
• Blocked air intake.
• Cooling fan breakdown.
• Internal circuit failure.
• Cooling down.
• Burnt-out lamp.
• Lamp circuit failure.
• The lamp caga cover is
not securely installed.
• Lamp has been used for
over 1,400 hours.
Reset the lamp timer.
2
1 Press KEYSTONE (+) and
KEYSTONE (–) simultaneously and
ON/OFF at the same time.
• The warning lights on the projector indicate problems
inside the projector.
• There are two warning lights: a TEMPERATURE
WARNING indicator which warns that the projector is too
hot, and a LAMP REPLACEMENT indicator which lets
you know when to change the lamp.
• If a problem occurs, either the TEMPERATURE WARNING
indicator or the LAMP REPLACEMENT indicator will
illuminate red. After turning off the power, follow the
procedures given below.
• Relocate the projector to an area with proper
ventilation.
• Take the projector to your nearest Sharp
Authorized Projector Dealer or Service
Center for repair.
• Wait until the indicator stops flashing and
turns off.
• Carefully replace the lamp.
• Take the projector to your nearest Sharp
Authorized Projector Dealer or Service
Center for repair.
1
23
PG-M15X
PG-M15S
AN-M15T
Possible Solution
"LAMP 0000H" is
displayed, indicating that
the lamp timer is reset.