Scope Of Delivery - Scheppach HMS850 Originalbetriebsanleitung

1. Introduction
MANUFACTURER:
scheppach
Fabrikation von Holzbearbeitungsmaschinen GmbH
Günzburger Str. 69
D - 89335 Ichenhausen
DEAR CUSTOMER,
We hope your new tool brings you much enjoyment
and success.
NOTE:
According to the applicable product liability laws, the
manufacturer of the device does not assume liability
for damages to the product or damages caused by
the product that occurs due to:
• Improper handling,
• Non-compliance of the operating instructions,
• Repairs by third parties, not by authorized ser-
vice technicians,
• Installation and replacement of non-original
spare parts,
• Application other than specified,
• A breakdown of the electrical system that occurs
due to the non-compliance of the electric regu-
lations and VDE regulations 0100, DIN 57113 /
VDE0113.
We recommend:
Read through the complete text in the operating
instructions before installing and commissioning the
device. The operating instructions are intended to
help the user to become familiar with the machine
and take advantage of its application possibilities in
accordance with the recommendations.
The operating instructions contain important
information on how to operate the machine safely,
professionally and economically, how to avoid
danger, costly repairs, reduce downtimes and how to
increase reliability and service life of the machine.
In addition to the safety regulations in the operating
instructions, you have to meet the applicable regula-
tions that apply for the operation of the machine in
your country.
Keep the operating instructions package with the
machine at all times and store it in a plastic cover to
protect it from dirt and moisture. Read the instruc-
tion manual each time before operating the machine
and carefully follow its information. The machine can
only be operated by persons who were instructed
concerning the operation of the machine and who
are informed about the associated dangers. The
minimum age requirement must be complied with.
In addition to the safety instructions contained in
this manual and the specific country regulations the
generally accepted technical rules must be observed
for the operation of woodworking machines.
2. Layout (Fig. 1-19)
1. On/Off switch
2. Slide block
3. Push stick
4. Hand crank
5. Chip extractor
6. Parallel stop
7. Clamping lever
8. Mounting for planing knife cover
9. Setting knob for the chip depth
10. Workpiece support
11. Rubber foot
12. Planing knife cover
13. Feed table
14. Planing table
15. Blade adjustment block
16. Allen wrench - small
17. Open-ended spanner
18. Scale (Fig.3)
19. Pointer (Fig.3)
20. Thicknessing table
21. Blade
22. Latch
23. Knife block
24. Anti-kick claws
25. Mounting with knife cover plate (Fig.5)
26. Allen wrench - medium
27. Chip extractor adapter Ø 100 mm
28. Allen wrench - large
29. Scale (Fig.6)
30. Pointer (Fig.6)
31. Locking screw
32. Knurled screw
33. Locking screw
34. Fixing screw chip extractor
35. Overload switch
36. Washer
37. Allen screw
38. Scale (Fig.5)
39. Pointer (Fig.5)
40. Blade covering plate

3. Scope of delivery

• Open the packaging and remove the device
carefully.
• Remove the packaging material as well as the
packaging and transport bracing (if available).
• Check that the delivery is complete.
• Check the device and accessory parts for trans-
port damage.
• If possible, store the packaging until the warranty
period has expired.
ATTENTION!
The device and packaging materials are not
toys! Children must not be allowed to play with
plastic bags, film and small parts! There is a
risk of swallowing and suffocation!
GB 19