Use As A Hand Steam Cleaner - Cleanmaxx Z 04997 Gebrauchsanleitung

steam is emitted. Engage the child lock by pushing the safety button to the back position. Wait
until the device has cooled off.
10. Empty the water tank. Only screw the water tank cap closed once the inside of the water
tank has dried.
11. Take the fl oor cleaning cloth off of the fl oor nozzle and wash it out (see chapter "Cleaning
and storage").
12. Store the device upright in a cool and dry place.
13. Prior to using the device again, the water tank should always be checked for residual water
and be completely emptied if necessary.

Use as a hand steam cleaner

1. Prepare the device as described in the chapter "Start-up", section "Mounting accessory noz-
zles".
2. Fill the water tank with water (see chapter "Start-up", section "Filling the water tank").
3. Insert the mains plug in a properly installed socket that is easily accessible.
4. Push the On/Off switch. The power light and the heat control light will activate. The heating
control light turns off after approximately 8 minutes once the device has reached the oper-
ating temperature.
5. Press the safety switch to the intermediate (high steam setting) or forward
position (low steam setting). This releases the child lock at the same time.
6. Pushing the steam trigger will emit steam from the nozzle. Move the nozzle
slowly back and forth across the surface to be cleaned and push down the
steam trigger as needed.
7. If the water tank is empty and steam is no longer produced, push the On/Off switch and pull
the mains plug out of the socket; the power light will turn off. Push down the steam trigger to
release any residual steam and pressure until no more steam is emitted. Engage the child lock
by pushing the safety button to the back position. Wait until the device has cooled off. Fill the
water tank (see chapter "Start-up", section "Filling the water tank").
8. Once you are done cleaning, push the On/Off switch and pull the mains plug out of the sock-
et. Push down the steam trigger to release any residual steam and pressure until no more
steam is emitted. Engage the child lock by pushing the safety button to the back position. Wait
until the device has cooled off.
9. Empty the water tank. Only screw the water tank cap back on once the inside of the water
tank has dried.
10. Remove the nozzles and stow them in the storage compartment.
11. Store the device upright in a cool and dry place.
12. Prior to using the device again, the water tank should always be checked for residual water
and be completely emptied if necessary.
25