Wet Vacuum Cleaning; Turning On The Appliance - Kärcher IVC 60/24-2 Tact2 M Betriebsanleitung

Illustration
 Insert the disposal bag so that it is snug
against the reservoir wall and the reser-
voir bottom.
 Pull disposal bag over the container.
 Replace the battery and lock it with the
sliding bow.
Warning
Crush hazard. Never hold your
hands between the dirt contain-
er and the intermediate ring or
put them near the lifting mecha-
nism while locking. Lock the container by
pressing the sliding bow with both hands.
 Plug in the pressure balancing.

Wet vacuum cleaning

Caution: Constantly monitor the fill level
in the dirt receptacle when vacuuming
high volumes of liquid, as the receptacle
can be filled within a matter of seconds
and could overflow.
Danger
No dusts hazardous to health should be
sucked in during wet vacuuming.
To suck wet dirt, always remove the dis-
–
posal bag.
Removing the dust disposal bag
 Lock parking brakes.
Illustration
 Remove the pressure balancing at the
upper end.
 Pull the locks of the placement mechan-
ics up.
 Pull the push handle upward. The con-
tainer is unlocked and lowered.
Illustration
 Pull the container out by the handle.
Illustration
 Put the disposal bag over.
 Tightly seal the disposal bag with clo-
sure strips underneath the opening.
 Remove disposal bag.
 Dispose of the disposal bag according
to the local provisions.
 Replace the battery and lock it with the
sliding bow.
Warning
Crush hazard. Never hold your
hands between the dirt contain-
er and the intermediate ring or
put them near the lifting mecha-
nism while locking. Lock the container by
pressing the sliding bow with both hands.
 Plug in the pressure balancing.
General
Caution
Please observe the local provisions regard-
ing the wastewater treatment.
If wet dirt is vacuumed with the crevice
–
nozzle or if high volumes of liquid are
sucked up from a container, it is recom-
mended to deactivate the "Filter
Dedusting" function.
After the wet vacuuming: Clean the flat-
–
fold filter. Clean the container with a
damp rag and dry it.

Turning on the Appliance

 Plug in the main plug.
 Switch on the appliance at the rotating
knob.
Adjust the suction hose cross
Note: The different suction hose sections
are required to allow an adjustment to the
connection sections of the accessory parts.
 Set the minimum volume flow for the
suction hose cross section at the rotary
switch.
The scale displays the suction hose cross
section.
– 4
EN
Rotating knob
Appliance ON
–
Filter dedusting OFF
–
Appliance OFF
–
Appliance ON
–
Filter dedusting ON
–
section
19