Automatic Filter Cleaning; Storing The Appliance; Transport; Storage - Kärcher IVC 60/24-2 Tact2 M Betriebsanleitung

Automatic filter cleaning

The appliance has an innovative dual filter
cleaning system that is particularly effective with
fine dust. The flat pleated filter is automatically
cleaned every 7.5 seconds through an air jet
(pulsating sound).
Turn off the appliance
 Switch off the appliance at the rotating
knob.
 Pull out the mains plug.
After each operation
Empty the container
 Lock parking brakes.
Illustration
 Remove the pressure balancing at the
upper end.
 Pull the locks of the placement mechan-
ics up.
 Pull the push handle upward. The con-
tainer is unlocked and lowered.
Illustration
 Pull the container out by the handle.
 Empty the container.
 Replace the battery and lock it with the
sliding bow.
Warning
Crush hazard. Never hold your
hands between the dirt contain-
er and the intermediate ring or
put them near the lifting mecha-
nism while locking. Lock the container by
pressing the sliding bow with both hands.
 Plug in the pressure balancing.
Cleaning the device
 Vacuum and wipe the appliance inside
and outside with a damp cloth.

Storing the Appliance

 Wrap the mains cord around the cable
holder.
 Wind the suction hose around the slid-
ing bow.
 Insert the floor nozzle and the suction
pipe into their respective holder.
 Place the appliance in a dry room and
secure it from unauthorized use.
20
Caution
Risk of injury and damage! Observe the
weight of the appliance when you transport it.
 Close the suction connection, see oper-
ating instructions.
 Release the park brakes and push the
appliance by the push handle.
 Grab the appliance by the chassis, not
by the sliding bow to load it.
 When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
Caution
Risk of injury and damage! Note the weight
of the appliance in case of storage.
This appliance must only be stored in inte-
rior rooms.

Maintenance and care

Danger
First pull out the plug from the mains before
carrying out any tasks on the machine.
Dust extracting machines are safeguards
for the prevention or elimination of hazards
defined in the regulations of BGV A1.
In order to carry out maintenance work,
–
the user must disassemble, clean and
service the unit, in so far as this is pos-
sible without endangering maintenance
personnel and other persons. Suitable
precautions include decontamination
before the unit is disassembled. Pre-
cautions must be taken for local filtered
forced air ventilation at the place where
the unit is dissassembled, the cleaning
of the maintenance surface and suita-
ble protection of the personnel.
The outside of the unit should be
–
cleaned thoroughly and any harmful
substances removed. Alternatively, a
sealed coating may be applied before
the unit is removed from the danger ar-
ea. All unit parts are to be considered
– 5
EN

Transport

Storage