Device Elements; Start Up; Power Connection; Dry Vacuum Cleaning - Kärcher NT 70/2 Tc Handbuch

Device elements

1 Star screw
2 Cartridge filter
3 Mechanical overflow protection
4 Suction head
5 Suction hose
6 Push handle
7 Cable hook
8 Suction head lock
9 Dirt receptacle
10 Suction support
11 Tilting chassis
12 Container handle
13 Steering roller
14 Floor nozzle
15 Suction tube
16 Carrying handle
17 Bender
18 Appliance switch suction turbine 2
19 Appliance switch suction turbine 1
20 Appliance switch suction turbine 3
21 Storage for floor nozzle
22 Drain hose
23 Holder for suction pipes
24 Holder for crevice nozzle
25 Power cord
26 Nameplate

Power connection

ATTENTION
The highest allowed net impedance at the
electrical connection point (refer to techni-
cal data) is not to be exceeded. In case of
confusion regarding the power impedance
present on your connection, please contact
your utilities provider.
12

Start up

Dry vacuum cleaning

ATTENTION
Risk of damage! The cartridge filter must
never be removed during vacuuming.
– When vacuuming fine dust, you may
also use an additional paper filter bag or
a membrane filter (special accessory).
Inserting the paper filter bag (option)
Illustration
 Release and remove the suction head.
 Insert the paper filter bag or the mem-
brane filter (special attachment).
 Insert and lock the suction head.

Wet vacuum cleaning

Inserting the rubber lips
Illustration
 Remove the brush strips.
 Install the rubber lips.
Note: The structured side of the rubber lips
must point outwards.
Remove the paper filter bag
– If the appliance is used to vacuum wet
dirt the paper filter bag or the mem-
brane filter (special accessory) must al-
ways be removed.
– It is recommended to use a special filter
bag (wet) (see Filter systems).
Wet vacuuming with cartridge filter
ATTENTION
Risk of damage! The cartridge filter must
never be removed during vacuuming.
– After the wet vacuuming: Clean the me-
chanical overflow protection and the
container with a damp rag and dry
them.
– If you change immediately from wet to
dry vacuuming, then replace the wet
cartridge filter with a dry one.
– 2
EN