Device Elements; Dry Vacuum Cleaning; Wet Vacuum Cleaning - Kärcher NT 25/1 Ap Te Originalbetriebsanleitung

Device elements

1 Electrodes
2 Suction hose
3 Air outlet, working air
4 Suction head lock
5 Air inlet, motor cooling air
6 Dirt receptacle
7 Steering roller
8 Suction head
9 Suction support
10 Floor nozzle
11 Main switch
12 Suction tube
13 Carrying handle
14 Cable hook
15 Filter cover
16 Button for filter shake off system
17 Hose holder
18 Socket
19 Indicator lamp
20 Bender
21 Flat fold filter
22 Filter dedusting
23 Floor nozzle holder
24 Power cord
25 Nameplate
26 Holder for suction pipes
27 Holder for crevice nozzle
28 Holder for accessories
ATTENTION
The flat pleated filter must always be in
place while vacuuming.
Anti-static system
Only for appliances with built-in socket:
Static charge is deflected by providing
earthing to the connection nozzles. This
prevents the formation of sparks and cur-
rent shocks due to attachments (option)
with electrical conductivity.
14
Start up

Dry vacuum cleaning

– To vacuum up fine dust, a fleece filter
bag or a membrane filter (special ac-
cessory) can additionally be used.
Install fleece filter bag
Illustration
 Release and remove the suction head.
 Insert the fleece filter bag.
 Insert and lock the suction head.
Install membrane filter
Illustration
 Release and remove the suction head.
 Pull the membrane filter (option) over
the container edge.
 Insert and lock the suction head.
Changeover from wet to dry vacuum
cleaning
ATTENTION
Please note the following when switch-
ing from wet to dry vacuum cleaning:
If you vacuum dry dust while the filter ele-
ment is still wet the filter will become ob-
structed and may be damaged beyond re-
pair.
 Dry the wet filter properly before use or
replace it with a dry one.
 Change the filter, if required, according
to instructions under the section "Main-
tenance and Care".
Note: For permanent wet vacuum cleaning
it is advisable to use a PES flat pleated filter
(see filter systems).

Wet vacuum cleaning

Inserting the rubber lips
Illustration
 Remove the brush strips.
 Install the rubber lips.
Note: The structured side of the rubber lips
must point outwards.
– 2
EN