Electrical Safety; Machine Information - Ferm COM1007P Originalbetriebsanleitung

completely before removing any work piece or
change the settings.
8. Before installing the disc, always inspect the
resin and rubber treated disc for shearing.
9. Always cross-check the maximum operating
speed of the disc cutting saw with the
maximum permitted speed of the motor. Never
exceed the maximum permitted operating
speed indicated on the disc.
10. Never try to mount a disc onto the machine by
force, or to change the size of the axles. Never
use discs which do not fit. Only use discs
which fit the machine.
11. Do not attempt to attach saw blades to the
machine, as it is not designed to cut wood.
12. Do not start cutting until the motor has
reached full speed.
13. If, while operating the machine, the disc no
longer turns or the motor sounds overloaded,
switch off the machine immediately.
14. Keep easily flammable or fragile objects away
from the machine. The machine operator must
avoid letting his or her hands, face or feet
come into contact with the sparks caused
when cutting.
15. Position your machine firmly on a flat, even
surface.
16. Only operate the machine at the voltage stated
on the nameplate.
17. Never touch a sawn-off workpiece, always let
it cool down first.
18. Never attempt to cut workpieces which
exceed the permitted size.
19. During cutting, never position yourself in the
direction of cutting. Always remain to one side.
20. Always leave safety devices installed.
21. Always ensure that you cut slowly and
carefully. Avoid applying the disc to the
workpiece with a jerky motion.
22. Never push the workpiece towards the disc
while holding it in your hands. Always use the
clamp to fix the workpiece.
23. Keep hands away from the cutting disk. Never
cut work pieces where manual support is
needed closer than 15cm from the rotating disk.
24. Make sure the work piece is properly supported
25. Never use cutting fluids. These fluids could
ignite or cause electrical shock
26. Do not cut cast-iron materials
27. Do not cut plastics, wood or synthetic materials
28. Do not cut magnesium

Electrical safety

When using electric machines always observe the
safety regulations applicable in your country to
reduce the risk of fire, electric shock and personal
injury. Read the following safety instructions and
also the enclosed safety instructions. Keep these
instructions in a safe place!
Always check that the power supply
corresponds to the voltage on the rating
plate.
Class II machine – Double insulation –
You don't need any earthed plug.
Replacing cables or plugs
If the mains cable becomes damaged, it must
be replaced with a special mains cable available
from the manufacturer or the manufacturer's
customer service. Dispose of old cables or plugs
immediately after replacing them with new ones. It
is dangerous to connect the plug of a loose cable
to a socket.
Using extension cables
Only use an approved extension cable suitable
for the power input of the machine. The minimum
conductor size is 1.5 mm2. When using a cable
reel always unwind the reel completely.

2. MACHINE INFORMATION

Intended use
The chop saw has been design for cutting steel
materials in various shapes.
Technical specifications
Mains voltage
Mains frequency
Power input
Rated speed
Saw blade dimensions*
Sound pressure
L
PA
Sound capacity
L
WA
Vibration a
h, AG
Weight
220V-240V~
50Hz
2.300 W
4.000/min
Ø 355mm x Ø 25.4mm
93 dB(A) K=3
105 dB(A) K=3
2.90+1.5 m/s2
15.8kg
7