Jackle Plasma 25ci IP23 Betriebsanleitung Seite 13

Operating manual
Plasma 25ci
General information's:
These operating instructions are intended to ensure safe and efficient work with this cutting unit.
Prior to initial operation of the unit, read the instructions carefully.
The information contained in this manual should be made available to all operational staff. These
instructions should always be kept ready-to-hand, near the machine.
Warning:
Electromagnetic compatibility EMC (IEC 60974-10):
This class A cutting unit is not provided for use in housing areas, where the electric power supply
comes from a public low voltage supply.
It may possible, that through wire fixed or radiate disturbances, it isn't easy to guarantee electro-
magnetic compatibility in these areas.
INFORMATION: The user is responsible for the trouble, which the machine generates during the
operation. He must rate and consider possible electromagnetic problems in the neighbourhood.
Attention:
Safety check:
This cutting unit has to be safety checked least once a year by JÄCKLE Company or another special
qualified electrician according to the harmonized standard
IEC 60974 – 4
Safety, maintenance and inspection of arc welding equipment in use
Power cord and power plug:
According to the standard DIN EN 60974 - part 1, point 10.9 and 10.10, paragraph b)
...must these be rated for the largest effective line current I
They do NOT have to be rated according to the maximum line current!
Warranty:
INFORMATION: Improper repair or servicing, technical modifications of the product, unauthorized,
not strictly from JÄCKLE GmbH permitted modifications, as well as carelessness at the installation or
use, or the nonobservance of care in own affairs lead to the extinction of every warranty.
Observe protection notice ISO 16016
Subject to mistakes and technical modifications !
Operating manual
(see rating plate)...
1eff
Plasma 25ci
Page 11