Display And Control Elements - Conrad 75 17 50 Bedienungsanleitung

5. Display and Control Elements

The illustrations are located on the front fold-out page.
1) "DC lens adjustment switch"
For auto iris-Objectives with DC control, this can be used to adjust the lens. For
auto iris objectives with video signal control, this setting is performed at the
objective
2) "Control signal selection switch"
Use this switch to select the control signal required for your objective. (See
chapter "10. Set Control Signal")
3) "Function selection switch"
(See chapter "9. Set Function Selection Switch")
4) "VIDEO OUT" connection (BNC)
Video signal output
5) "POWER" status LED
The LED is lit in red when the power supply is connected correctly
6) Connection cable with safety plug 230V/AC 50 Hz
7) Locking screw for focal width adjustment
8) Locking screw for sharpness adjustment
9) Control socket
10) Plug for control socket
11) Mounting base attachment
A mounting base is available optionally
23