b) Mounting the Camera with the "Hook and Loop Tape"
(25 or 26)
Attach the "rubber pad" (23) to
the bottom of the "helmet holder"
(18).
1+2# Place the "helmet holder"
(18) on the helmet and guide the
"hook and loop tape" (25 or 26)
on, e.g, the helmet.
3# Guide the "hook and loop
tape" (25 or 26) through the "hel-
met holder" (18)
4# Push the camera into the "helmet holder" (18) now. To ensure tight fit, adjust the
camera angle.
c) Mounting the Camera with the "Control Rod Holder (17)
1# Put the "control rod holder" (17) onto the control rod.
2#Tighten the fastening screws and nuts to ensure tight fit.
3# Insert the camera into the "control rod holder" (17) and ensure that the camera is
locked in the "control rod holder" (17).
4# Adjust the camera angle.
31