Werbung
Installation de surveillance à caméra radio numéro de réf.
751056 (caméra couleur)
Caméra radio:
Tension d'alimentation
12 V CC (adapteur secteur)
Consommation de courant
280 mA
Tension de sortie fiche Jack 12 VCC / 250 mA
Porteuse
2,4 GHz - 2,4835 GHz
Modulation
FM
Nombre de canaux
4
Niveau de sortie vidéo
1 V de crête à crête/ 75 ohms 1 Vde crête à crête / 75 ohms
Niveau de sortie audio
1 V cr. à cr. / 600 ohms, mono 1 Vcr.à cr. / 600 ohms, mono
Antenne
50 ohms, douille SMA
Douille de raccordement
audio/vidéo
Cinch
Capteur photosensible
1/3" à technologie CMOS
Dimensions de l'image/pixel 628 (horizontal) x 582 (vertical)
Résolution horizontale
> 320 lignes par image
Luminance minimale
5 Lux
Lentille
F6,0 mm F1,8 50 °
Microphone
Microphone à condensateurs, mono
Image
en couleurs
Portée
Env. 50 m à vue non obstruée
(dépend fortement des
conditions environnementales)
Température d'emploi
entre 0°C et +40°C
Poids
185 g
Dimensions sans antenne
75 mm (L) x 45 mm (H) x
140 mm (L)
Adaptateurs secteur
Tension d'alimentation
230 V~ 50 Hz
Tension de sortie
12 V CC / 600 mA
70
Récepteur
12 V CC (adapteur secteur)
330 mA
2,4 GHz - 2,4835 GHz
FM
4
50 ohms, douille SMA
Cinch
160 g
75 mm (L) x 45 mm (H) x
140 mm (L)
The receiver and the radio-controlled camera are designed for the
connection to the video or audio input of a television set or a video
recorder.
The receiver and the radio-controlled camera are approved only for
connection to the mains units which are enclosed.
The entire set may only be used inside, not outdoors. Contact with
water, e. g. in bathrooms is to be avoided.
The radio camera ystem is not designed for industrial use.
A use different to the one described above damages the product,
moreover, this involves dangers, like e.g. short-circuit, burning,
electric shock etc.
The entire product must not be modified or rebuilt and the housing
must not be opened!
The safety instructions are to be observed!
Control elements (fold-out page)
Connection and control elements of the radio-controlled came-
ra See Figure 1, Figure 1a, Figure 1b and Figure 1c on the fold-
out page
(1) Camera lens
1/3 inch CMOS colour, or 1/4 inch CMOS B/W sensor with rigid
lens, angular coverage 50 °
(2) Antenna
The antenna radiates the high-frequency signal of the transmit-
ting unit. The antenna can be screwed off and should be pla-
ced vertically pointing upwards to achieve the best transmissi-
on conditions.
(3) IR (infrared) lighting (only for order-no. 751082 B/W radio
camera)
These IR luminous diodes facilitate operation of the camera
even at night-time; the range of the lighting is approx. 1 m.
(4) Microphone
There is a highly sensitive capacitor microphone within the
inner housing.
27
Werbung
Kapitel
