Removing The I/O Module - WAGO LON FTT 753-648 Bedienungsanleitung

WAGO-I/O-SYSTEM 753
®
753-648 LON FTT Module
Figure 10: Snap the I/O module into place
With the I/O module snapped in place, the electrical connections for the data
contacts and power contacts (if any) to the fieldbus coupler/controller or to the
previous or possibly subsequent I/O module are established.
Pos: 61.11 /Serie 750 (WAGO-I/O-SYSTEM)/Montieren/Busklemme entfernen @ 4\mod_1239169375203_21.doc @ 30334 @ 3 @ 1
4.2.2

Removing the I/O Module

1. Remove the I/O module from the assembly by pulling the release tab.
Figure 11: Removing the I/O module
Electrical connections for data or power contacts are disconnected when removing
the I/O module.
Pos: 61.12 /Dokumentation allgemein/Gliederungselemente/---Seitenwechsel--- @ 3\mod_1221108045078_0.doc @ 21810 @ @ 1
Manual
V1.0.0
Mounting 29