Other Hot Beverages; Water Level Control Of Boiler - Faema E61 Handbuch

English

Other hot beverages

Steam dispensing
Put a cup with the beverage you wish to heat under the right or left
steam nozzle (6).
Completely immerse the steam nozzle in the beverage.
Gradually open up the steam ta (7) , allow the beverage to heat to the
desired temperature, stop the flow of steam by turning knob (7) the other
way (towards “0”).
Dispensing hot water
Put the pot below of pipe (8) and open the tap (9).
9
8

Water level control of boiler

The machine is fitted with a series of automatic level control devices to
keep the water in the boiler at a pre-set level.
Filling the boiler with water using the manual service tap
This function should be used only if the electronic level control devices
are not working correctly.
Press the filling lever (5), taking care not to exceed the MAX. level on
the boiler water level indicator (13).
Heating milk for frothy coffee (cappuccino)
Use a tall narrow jug and fill it up to about the half-way mark. Then
plunge the steam jet pipe (6) into the milk.
Gradually open up the steam tap (7) and heat the milk for a few seconds.
When the required amount of froth has been made and the temperature
is sufficiently high, stop the flow of steam by turning knob (7) the other
way (towards “0”).
When the steam jet pipe (6) is no longer required, clean it thoroughly
with a sponge and a clean cloth.
Note: At the conclusion of each steam dispensing phase,
clean the inside of the steam nozzle as follows:
Turn the nozzle towards the cup tray and carefully
activate steam dispensing at least once.
7 7
6 6
13
9
8
5
English
7
6