Filling The Water Reservoir - Cleanmaxx Z 06456 Gebrauchsanleitung

1. Plug the adapter (2) as far as it will go onto the steam nozzle (19) of the device and
screw it on tight.
2. Screw the connecting piece into the fl oor attachment.
3. Push the narrow end of the extension tube into the connecting piece. The locking
lug of the extension tube must lock in the matching opening in the connecting piece.
4. In the same way, plug the adapter into the open end of the extension tube or, for a
longer tube, the second extension tube and then the adapter into this.
Floor Cloth
Use the fl oor cloth to gently wipe down the fl oor.

Filling the Water Reservoir

CAUTION!
• Always pull out the mains plug and allow the device to cool down completely before
you open the water reservoir. Otherwise there could be an uncontrolled emission of
steam.
• Do not overfi ll the water reservoir. Pour a maximum of 260 ml of water into the device.
• Never hold the device under the tap and never immerse it in water to pour water into
the reservoir.
• Never pour any cleaning agent or other additives into the device. This could destroy
the device and safe working is no longer guaranteed.
1. The device has a safety reservoir cap (12). It cannot be removed if the water reser-
voir is pressurised. Press the reservoir cap down and unscrew it in the anticlockwise
direction.
To release pressure from the water reservoir, keep pressing the steam trigger (15)
until steam stops emerging from the device. The water reservoir can then be
opened.
2. Pour water into the water reservoir using the measuring cup and the funnel supplied.
3. Screw the reservoir cap back into the device.
06456_de-en-fr-nl_V1.indb 23 06456_de-en-fr-nl_V1.indb 23
23
• To disassemble the extension tube, press the release but-
tons on the extension tube and adapter and pull it out.
• To remove the adapter from the device, turn it in the op-
posite direction and pull it off.
1. The fl oor attachment (4) has two clips on the top of it.
Press down the end of the clip in the middle of the fl oor
attachment to open the clip.
2. Insert one end of the fl oor cloth and release the clip.
3. Stretch the fl oor cloth over the bottom of the fl oor attach-
ment and secure it in the second clip.
EN
03.07.2015 10:28:03 03.07.2015 10:28:03