Information On Usage - Kärcher SC1100 Betriebsanleitung

Hot water can drip out of accessories while
you are detaching them. Do not detach acces-
sories while steam is being discharged – danger
of scalding!
Do not add pour any detergents or other additi-
ves into the boiler.
Do not switch the cleaner on if there is no water
in the boiler, otherwise it could overheat. As a
safety measure, the cleaner’s heater switches
off automatically and the low-water warning
lamp (A6 illuminates. In order to be able to use
the cleaner again, wait approx. 10 minutes for it
to cool down and then fill the boiler with water
(see 2.6 “Filling up with water”).
Note: When the water in the boiler has been used up,
the low-water warning lamp (A6) will illuminate. The
safety cap (A2) cannot be opened while there is any
pressure at all in the boiler.
English
12
If the cleaner has been in continuous use for a
long time, the safety cap (A2) may be hot!
If the boiler is still hot, there is a risk that water
will be squirted back while it is being poured into
the boiler and cause scalding.
Fig. 2: Pull out the accessory plug

3. Information on usage