Bosch MUZ9HA1 Gebrauchsanleitung Seite 12

en Preparation
Whirl maker
For shaping biscuit dough or shortcrust
pastry.
Pasta maker
For making pasta.
Preparation of the foot
The foot is used for various models of the
base unit. The right height must be selected
depending on the model.
X Fig. B
1. To adjust the height, hold down the
button and slide the parts closer together
or further apart. When doing so, make
sure that the button clicks into place
audibly.
2. Short foot:
For models without display.
3. Long foot:
For models with display.
Preparation for meat mincer
Caution!
Always only use one perforated disc.
X Fig. C
1. Insert the worm gear with the agitator
paddle at the front in the housing.
2. First fit the knife and then the required
perforated disc onto the w orm gear.
Caution!
Fit the knife with the square projection at the
front onto the worm gear.
3. Fit the threaded ring onto the housing
and screw tight in a clockwise direction
without using force.
The meat mincer is now prepared.
Preparation for kebbe maker
X Fig. D
1. Insert the worm gear with the agitator
paddle at the front in the housing.
2. First fit the conical ring onto the worm
gear and then the kebbe nozzle into the
housing.
3. Fit the threaded ring onto the housing
and screw tight in a clockwise direction
without using force.
The kebbe maker is now prepared.
12
Preparation for sausage filler
X Fig. E
1. Insert the worm gear with the agitator
paddle at the front in the housing.
2. First fit the bearing ring onto the worm
gear and then the sausage nozzle into
the housing.
3. Fit the threaded ring onto the housing
and screw tight in a clockwise direction
without using force.
The sausage filler is now prepared.
Preparation for whirl maker
X Fig. F
1. Insert the worm gear with the agitator
paddle at the front in the housing.
2. First fit the bearing ring onto the worm
gear and then the holder for the shape
plate into the housing.
3. Fit the threaded ring onto the housing
and screw tight in a clockwise direction
without using force.
4. Slide the shape plate into the holder and
select the shape you require.
The whirl maker is now prepared.
Preparation for pasta maker
X Fig. G
1. Insert the worm gear with the agitator
paddle at the front in the housing.
2. First fit the pasta insert you require onto
the worm gear, followed by the matching
cover, into the housing.
3. Fit the threaded ring onto the housing
and screw tight in a clockwise direction
without using force.
The pasta maker is now prepared.