SPORTSTECH DFT500 Benutzerhandbuch Seite 50

What to lubricate?
Do not lubricate with other than our approved lubricant. Your treadmill comes with a 30ml tube of
silicone. For further lubrication, you may order from distributor for our 200ml silicone:
1. 200ml silicone in one bottle with 35cm applicator.
2. 100% silicone, non-petroleum base, contains of no harmful solvents, non-toxic and nonflammable.
3. Pump action spray bottle.
4. Good for the treadmill that used non-petroleum based lubricant.
3
2
1
How to lubricate?
Follow above drawing, lift running belt as high as possible, wipe the deck and the edge of the belt with
a clean lint free cloth to remove any dirt on both sides. Then inserting straw from silicone bottle from
either side of the running belt to reach to the deck surface about 18 inches from motor cover, pump
out the silicone of the tube across the deck, parallel to the motor cover, in about one foot line. The one
foot line should be in the middle of the deck at approximately equal distance from both side edges of
the belt. Repeat above procedures to distribute onto 3 spots on the running deck as shown on drawi-
ng. Once the silicone is applied, you should walk, not run, at low speed on the treadmill for at least 5
minutes to ensure it is evenly distributed.
You want the lubricant to be applied about the spot that your feet would hit the belt as you are walking.
This should be about 18 inches from the motor cover. You may walk on the treadmill to see where
your feet land on the belt. Please note if you mostly run on the treadmill, the spot where your feet land
may be different from the spot in walking.
50