Adjusting The Running Belt Tension; Tips - SPORTSTECH DFT500 Benutzerhandbuch

ADJUSTING THE RUNNING BELT TENSION

Adjust the belt tension if it begins to slip on the rollers. This is important as it increased the longevity
of the treadmills components.
Before adjusting belt tension, keep the belt loose.
1. Turn the MASTER POWER SWITCH to the ON position and make sure safety key is properly
placed onto the computer console.
2. Press START button to start running the belt, then increase speed to 3KPH.
3. Turn both adjustment screws an equal amount, approximately one-quarter turn clockwise.
4. Slow the belt by holding onto the handrails and applying more weights as you walk, (as if you are
walking downhill).
5. Then stepping heavily on the belt to see if the belt slips. If the belt slips, adjust one-quarter turn
clockwise and repeat STEP 4 if necessary.
CLEANING
Firstly, make sure the treadmill is off and unplugged from the electrical outlet.
To remove dust, use a small vacuum nozzle to carefully vacuum around all visible components.
To remove film or dust, use a slightly damp rag with a mild cleaning agent sprayed onto the rag only.
Be careful not to immerse any treadmill component with any liquids.
INSPECT FASTENERS AND WIRING
Check that all fasteners are properly tightened and all wiring is securely in place. To avoid damaging
fasteners, do not over tighten.
STORAGE
Store your treadmill in a clean and dry environment. Make sure the master power switch is off and is
unplugged from the electrical outlet.

TIPS

72