Kärcher HDS Super M Eco Originalbetriebsanleitung Seite 29

Continuous operation is worse than an
–
operation interrupted by pauses.
In case of regular, long-term operation of
the device and in case of repeated occur-
rence of the symptoms (e.g. cold, numb fin-
gers) please consult a physician.
Replace the nozzle
Danger
Switch the appliance off prior to replacing
nozzel and activate hand spray gun until
device is pressureless.
Turning on the Appliance
 Set the appliance switch to "I".
Indicator lamp for operational readiness
lights up.
Note: The temperature regulator must be
at "0" position because otherwise the burn-
er will switch off.
Note: If the control lamps fuel, liquid soften-
er or motor light up, please switch the appli-
ance off immediately and fix the error, see
"Help with errors".
The device starts briefly and turns off, as
soon as the working pressure is reached.
Figure 8
 Release the hand spray gun (A).
When activating the hand spray gun the de-
vice switches back on.
Note:If no water comes out of the high
pressure nozzle, vent pump. Refer to "Help
with malfunctions - appliance is not building
up pressure".
Adjust cleaning temperature
 Set temperature regulator to desired
temperature.
30 °C to 90 °C
Clean with hot water.
–
100 °C to 150 °C
Clean using steam.
–
 Replace the high-pressure nozzle with
steam nozzle (refer "Using steam").
Set working pressure and flow rate
Appliance setting
Figure 9
 Turn the regulation spindle in a clock-
wise direction: Increase working pres-
sure (MAX).
 Turn the regulation spindle in an anti-
clockwise direction: Reduce working
pressure (MIN).
Servo pressure regulation
 Set thermostat to max. 98 °C.
 Set the operating pressure on the appli-
ance to the maximum value.
Figure 8
 Set working pressure and flow rate
through turning (directly) at the pres-
sure- and amount regulation (B) of the
handgun (+/-).
Danger
When adjusting the pressure/quantity regu-
lation, make sure that the screw connection
of the spray lance does not become loose.
Note: For long term work with low pres-
sure, set pressure at device.
Operation with detergent
For considerate treatment of the envi-
–
ronment use detergent economically.
The detergent must be suitable for the
–
surface to be cleaned.
 With support of the detergent dose
valve set detergent concentration as
determined by the manufacturer.
Note: Recommended values at the control
panel at maximum working pressure.
 Set pressure/temperature and deter-
gent concentration according to the sur-
face to be cleaned.
Note: To prevent damage due to too much
pressure, always position high pressure ray
first from a greater distance towards object
to be cleaned.
– 6
EN
Cleaning
29