Cleaning And Care; Cleaning; Maintenance; Repair - Parkside PABS 16 B3 Betriebsanleitung

Cleaning and care

Q
WARNING!
Always switch the product off, remove
the battery pack and let the product
cool down before performing inspection,
maintenance and cleaning work!

Cleaning

Q
The product must always be kept clean, dry
o
and free from oil or grease. Remove debris
from it after each use and before storage.
Regular and proper cleaning will help ensure
o
safe use and prolong the life of the product.
Inspect the product before each use for worn
o
and damaged parts. Do not operate it if you
find broken and worn parts.
Never allow fluids to get into the product.
o
Clean the product with a dry cloth. Use a
o
brush for areas that are hard to reach.
In particular clean the air vents after every
o
use with a cloth and brush.
Remove stubborn dirt with high pressure air
o
(max. 3 bar).
NOTE
Do not use chemical, alkaline, abrasive or
u
other aggressive detergents or disinfectants
to clean this product as they might be harmful
to its surfaces.

Maintenance

Q
Before and after each use, check the product
and accessories (or attachments) for wear and
damage. If required, exchange them for new ones
as described in this instruction manual. Observe
the technical requirements (see "Technical data").

Repair

Q
This product does not contain any parts that can
be repaired by the user. Contact an authorised
service centre or a similarly qualified person to
have it checked and repaired.

Storage

Q
Switch the product off and remove the battery
o
pack 8 .
Push the rotation control switch
o
centre position to lock the on / off switch
Clean the product as described above.
o
Store the product and its accessories in a
o
dark, dry, frost-free, well-ventilated place.
14 GB
o
o
o

Transportation

Q
o
o
o
o
o
o

Troubleshooting

Q
Only perform the steps described within
u
these instructions! All further inspection,
maintenance and repair work must be
performed by an authorised service centre or
a similarly qualified specialist if you cannot
solve the problem yourself!
Suspected malfunctions are often due to causes
that the users can fix themselves. Therefore check
the product using this section. In most cases the
problem can be solved quickly.
Problem Possible cause
Product
does not
start
Product
6 to the
does not
reach full
.
7
power
Unsatis-
factory
result
Always store the product in a place that is
inaccessible to children. The ideal storage
temperature is between 10 °C and 30 °C.
We recommend using the original package for
storage or covering the product with a suitable
cloth or enclosure to protect it against dust.
Regularly check the charge level of the
battery pack, if it is to be stored for an
extended period. Optimum storage conditions
are cool and dry.
Switch the product off and remove the battery
pack 8 .
Push the rotation control switch
centre position to lock the on / off switch
Attach transportation guards, if applicable.
Always carry the product by its handle.
Protect the product from any heavy impact
or strong vibrations which may occur during
transportation in vehicles.
Secure the product to prevent it from slipping
or falling over.
WARNING!
Battery pack not
properly attached
Battery pack
discharged
Battery pack
damaged
Other electrical
defect to the product
Battery pack
capacity too low
Air vents are blocked
Accessory is worn
Accessory not suitable
for intended operation
to the
6
7 .
Solution
Attach properly
Remove and charge
the battery pack
Check by a
specialist electrician
Check by a
specialist electrician
Remove and charge
the battery pack
Clean the air vents
Replace with a new
one
Use suitable
accessory