Torque Control; Bit Holder; Led Work Light; Switching On And Off - Parkside PABS 16 B3 Betriebsanleitung

Torque control

Q
This product is equipped with a torque control that
disengages the spindle when a predefined torque
is exceeded.
The torque can be adjusted using the torque
o
sleeve .
2
Select a low level for small screws or soft
o
materials.
Select a high level for large screws, hard
o
materials or removing screws.
Select the drill setting for drilling operation by
o
turning the torque sleeve

Bit holder

Q
Use the bit holder to store an extra driver bit
4
for operations that require a frequent change of
the accessories.

LED work light

Q
This product is equipped with a LED work light
to illuminate the immediate working area to
improve visibility in poorly lit areas.
1. As long as the on-off switch
the LED work light
soon as the on / off switch is released.

Switching on and off

Q
Switching on:
1. Press the on / off switch
product on. Regulate the speed as required
(see "Speed control").
Switching off:
1. Release the on / off switch
product off.

After use

Q
1. Switch the product off, remove the battery
pack and let it cool down.
8
2. Check, clean and store the product as
described below.
to the position .
2
is pressed,
7
is lit and switches off as
10
to switch the
7
7 to switch the

Tips and tricks

Q
Before operating the product, check whether
o
the screw or drill bit is correctly positioned,
i.e. centred in the spindle.
Screw bits are labelled according to their
o
dimensions and their shape. If you are
uncertain, always check whether the bit fits
tightly in the screw head without any free play.
Torque
Smaller screws / bits can be damaged if you
o
set the torque or rotational speed too high.
Hard screw joints (in metal)
Particularly high torque occurs, for example in
o
metal screw joints made using drive sockets.
Select a low rotational speed.
Soft screw joints (e.g. in soft wood)
Again, use a low rotational speed, e. g. to
o
avoid damaging the surface of the wood
upon contact with the screw head. Use a
countersink.
10
Drilling in wood, metal and other materials
Use a high speed for drill bits with small
o
diameter and a low speed for drill bits with
large diameter.
Select a low speed for hard materials and a
o
high speed for soft materials.
Secure or fasten the workpiece in a clamp or
o
vice (if possible).
Mark the spot where you want to drill using a
o
centre punch or nail. Select a low rotational
speed when starting.
Pull the rotating drill bit from the hole
o
repeatedly to remove dust and chips and
clear the hole.
Drilling in metal
Use a metal drill (HSS). For optimum results,
o
cool the drill bit with cooling lubricant (cutting
oil). Metal drill bits can also be used to drill
into plastics. Start with a 3 mm diameter drill
bit and then increase the size until the desired
hole diameter is achieved.
Drilling in wood
Use a wood drill with a lathe centre; for deep
o
holes, use an auger bit; for large-diameter
holes, use a Forstner bit. Small screws can be
screwed directly into soft wood.
GB 13