Mains Part - Beurer BM 60 Gebrauchsanweisung

Technical information is subject to change without notification
to allow for updates.
• This unit is in line with European Standard EN 60601-1-2
and is subject to particular precautions with regard to elec-
tromagnetic compatibility (EMC). Please note that portable
and mobile HF communication systems may interfere with
this unit. More details can be requested from the stated Cus-
tomer Service address or found at the end of the instructions
for use.
• This device is in line with the EU Medical Devices Directive
93/42/EC, the "Medizinproduktegesetz" (German Medical
Devices Act) and the standards EN 1060-1 (non-inva-
sive sphygmomanometers, Part 1: General requirements),
EN 1060-3 (non-invasive sphygmomanometers, Part 3: Sup-
plementary requirements for electro-mechanical blood pres-
sure measuring systems) and IEC 80601-2-30 (Medical elec-
trical equipment – Part 2 – 30: Particular requirements for the
safety and essential performance of automated non-invasive
blood pressure monitors).
• The accuracy of this blood pressure monitor has been care-
fully checked and developed with regard to a long useful life.
If using the device for commercial medical purposes, it must
be regularly tested for accuracy by appropriate means. Pre-
cise instructions for checking accuracy may be requested
from the service address.

10. Mains part

Model no.
Input
Output
Supplier
Protection
Enclosures and
Protective Covers
24
FW 7575M/EU/6/06
100 – 240 V, 50 – 60 Hz
6 V DC, 600 mA, only in connection with
beurer blood pressure monitor.
Friwo Gerätebau GmbH
This device is double insulated and pro-
tected against short circuit and over-
load by a primary thermal fuse.
Make sure to take the batteries out
of the compartment before using the
mains part.
Polarity of the the DC voltage connec-
tion
Double insulated / equipment class 2
Equipment enclosed to protect against
contact with live parts, and with parts
which can become live (finger, pin,
hook test).
The operator shall not contact the
patient and the output plug of AC mains
part simultaneously.