J) Submenu "Hlc - Sygonix 1423058 Bedienungsanleitung

"DEF COLOR"
"SELECT"
"SWITCH"
"RANGE"

j) Submenu "HLC"

Permanently bright image areas may "burn in" even on modern flat screens if shown for a very long time.
Therefore, you can choose if such bright image areas (e.g. when the surveillance camera is pointed at bright
lamps or against the sun) should be concealed here.
When using plasma screens or old tube monitors, this process often takes only a few months.
If you use one of these screens, you should always activate this setting!
"MODE"
"BLACKNESS"
Set the colour for covering the image areas; 15 different colours are available. Ob-
serve that the colours are displayed grey in black/white display of the camera image
(e.g. at night)!
Select one of the 4 image areas here. Then you can switch the chosen image area
on and off with the "SWITCH" function. You can place it on the camera picture in the
function "RANGE".
Switch coverage for the image area chosen in "SELECT" (see above) "ON" or "OFF"
here.
After selecting the function and confirming with a brief push of the control lever, you
can select the image area to be covered.
Move the corner with the control lever (move it up, down, left or right), and confirm
your setting by briefly pushing the control lever.
In image area 1, every corner can be placed separately; image areas 2, 3 and 4 are
placed as a rectangle.
When choosing "ON", too-bright image areas are automatically masked/covered.
Here, you can set the colour in which the too-bright image area is masked/covered
(light grey.....black).
39