Before First Use; Filling The Water Tank - Silvercrest SDB 2400 A1 Bedienungsanleitung

Before first use
1) Remove the steam iron from the packaging.
2) Remove all stickers and protective foils from
the steam iron and from sole of the iron.
WARNING –
RISK OF SUFFOCATION!
Plastic bags can be dangerous. To avoid the
risks of asphyxiation, keep plastic bags out of
the reach of babies and toddlers.
GB
MT
3) Fill the water tank with water (See the chapter

"Filling the water tank").

4) Insert the plug into a mains power socket
supplying an electrical current as detailed
on the rating plate.
5) Switch on the iron and set it to temperature
level 9/MAX (see chapter "Operation").
6) Heat the steam iron up for several minutes at
this highest setting.
7) Activate the steam blast button
times so that steam comes out of the sole of
the iron.
8) Then iron over a piece of unwanted material
to remove any residues possibly remaining on
the sole of the iron.
9) Press the TEMP button
you hear a signal, the display
and indicates OFF.
10) Pull the power plug out of the socket.
42
Filling the water tank
1) Place the steam iron on the base
2) Open the cover of the filler opening for the
3) Using the measuring beaker
4) Close the cover of the filler opening for the
a couple of
repeatedly until
lights up red
water tank .
tank with water to the "MAX" marking, but no
further.
water tank .
NOTE
If the mains water in your area is rated as hard,
it is recommended that you mix the mains water
with some distilled water. Otherwise, the jets for
the steam blast function could calcify (become
blocked) prematurely.
To extend the optimal steam blast function, mix
mains water with distilled water according to the
table.
Water hardness
very soft/soft
medium
hard
very hard
The water hardness level can be queried at your
local water works.
.
, fill the water
Ratio of distilled
water to mains water
0
1:1
2:1
3:1
SDB 2400 A1