ABB ACSM1-04 Kurzanleitung Seite 5

Quick installation guide for
ACSM1-04 drive modules
This guide instructs briefly how to install the drive. For more detailed instructions,
engineering guide lines, technical data and complete safety instructions, see the Hardware
manual (www.abb.com/drives: Select Document Library and search for document number
3AUA0000117209 [English]).
Follow the safety instructions
WARNING! Ignoring the following instructions can cause physical injury or
death, or damage to the equipment:
•
Only qualified electricians are allowed to install and maintain the drive.
•
Never work on the drive, motor cable or motor when main power is applied. After
disconnecting the input power, always wait for 5 min to let the intermediate circuit
capacitors discharge before you start working on the drive, motor or motor cable.
•
Do not work on the control cables when power is applied to the drive or to the
external control circuits.
•
A rotating permanent magnet synchronous motor can generate a dangerous
voltage. Lock the motor shaft mechanically before connecting a permanent magnet
synchronous motor to the drive and before doing any work on a drive system
connected to a permanent magnet synchronous motor.
Select the power cables
Size the power cables according to local regulations to carry the nominal current given on
the type designation label of your drive. The maximum accepted cable size is
2
4 × (3 × 240) mm or 4 × (3 × 500 AWG).
Ensure the cooling
See the Hardware manual for the losses and the cooling air flow through the drive. The
allowed operating temperature range of the drive without derating is -10 to +40 °C
(14 to 104 °F).
Protect the drive and input power cable
See the Hardware manual for the suitable fuses.
Install the drive in the cabinet
See the figures on page
the figures are given below.
Quick installation guide for ACSM1-04 drive modules 5
3 for the drive module layout and mounting. The descriptions of
EN
DE
ES
FI
FR
IT
NL
RU
SV
TR
ZH
xx
xx