Installing The Ups Internal Batteries - Eaton Powerware 9140 Kurzanleitung

INSTALLATION
Optional
6
EATON Powerware
7. Install six cage or clip nuts as shown in Figure 4.
8. Slide the UPS into the rack. Verify that the rear mounting brackets engage in
and slide easily along the inside of the rails.
9. Secure the front of the cabinet to the rack as shown in Figure 4.
UPS
EBM
10. Replace the electronics module by sliding it carefully into the cabinet. Verify
that it seats against the rear of the cabinet.
Turn the module lock switch to the LOCK position.

Installing the UPS Internal Batteries

To install the battery trays into the UPS cabinet:
1. Verify that the output circuit breakers on the UPS rear panel are in the OFF (O)
position.
2. Slide the battery trays into the cabinet (see Figure 5). Push each tray in until
the battery tray lock on the handle catches to lock the tray in place.
®
9140 UPS (7.5–10 kVA) Quick Start
Figure 4. Securing the Front of the UPS
Figure 5. Installing the Battery Trays
S
164201678 Rev 1
Position 17
(M6 screw and
cage/clip nut)
Position 11
Position 8
Position 5 (M5 screw with
}
adapter plate)
Position 4
Position 3 (M5 screw)
Position 2 (M5 screw)
Battery Tray Lock