Code Selection - Datalogic Gryphon D432 Kurzanleitung

CODE SELECTION

issue identical codes = enable
Standard Code 39: no check digit control, variable code length;
EAN 8/EAN 13 / UPC A/UPC E without ADD ON: UPCE expansion disabled
Interleaved 2/5: check digit control and transmission, variable code length
Code 128: variable code length
PDF417
Datamatrix: rectangular, normal and inverted, variable code length
QR
Code 32, Codabar, Code 93, EAN 128, RSS, Micro PDF417, Postal Codes,
Maxicode, Composite Codes.
READING PARAMETERS
trigger type normal, trigger level mode, flash on = 2 sec, flash off = 2 sec,
beeper tone = tone 1, beeper volume = high, beeper duration = 50 ms, user
defined beeper = tone 1, user defined beeper volume = high, user defined
beeper duration = 100 ms, code per scan = one code per scan, read per
cycle = one read per cycle, scan timeout = 5 sec, central code transmission
enabled, order by code length disabled, order by code symbology disabled,
autoscan mode disabled, autoscan aiming system enabled, autoscan
hardware trigger enabled, autoscan illumination system disabled, stand
autoscan mode = normal, aiming system delay = disabled, good read spot =
disabled, safety time = 500 ms
IMAGE FORMATTING
Image Preset 1, 2, 3, 4
image format = JPEG, resolution = full (640 x 480), set JPEG quality
factor = 50, window origin = (0, 0), window dimensions = (640 x 480),
brightness = 0%, contrast = 0%, zoom = 100%, color depth = 256 gray level.
enabled codes
disabled codes
GRYPHON™ D432/D432E
13