Herunterladen Inhalt Inhalt Diese Seite drucken

Default Configuration; Camera Control - Datalogic Gryphon D432 Kurzanleitung

Vorschau ausblenden Andere Handbücher für Gryphon D432:
Inhaltsverzeichnis

Werbung

DATALOGIC

DEFAULT CONFIGURATION

RS232 Standard DEFAULT SETTINGS
115200 baud, no parity, 8 data bits, 1 stop bit, no handshake, no protocol,
FIFO enabled, intercharacter delay = 0, intercode delay = 0
USB COM Emulation DEFAULT SETTINGS
no handshake, no protocol, FIFO enabled, intercharacter delay = 0, intercode
delay = 0
USB Keyboard Emulation DEFAULT SETTINGS
USA keyboard*, intercharacter delay = 0, intercode delay = 0, FIFO enabled,
keyboard speed = normal
WEDGE Communication DEFAULT SETTINGS
USA keyboard*, CapsLock OFF, CapsLock Auto-Recognition ON, NumLock
OFF, intercharacter delay = 0, intercode delay = 0
DATA FORMAT – Symbology Independent Parameters
custom code identifier disabled, code identifier disabled, code length disabled
Default headers and terminators*:
-
RS232: no header, terminator = CR-LF
-
USB BULK: no header, terminator = CR-LF
-
USB COM: no header, terminator = CR-LF
-
USB Generic HID: no header, terminator = CR-LF
Wedge: no header, terminator = ENTER
-
USB Keyboard: no header, terminator = ENTER
-
DATA FORMAT – Symbology Dependent Parameters
symbology specific format = select all, no headers, no terminators, symbology
character substitution disabled, symbology character deletion disabled
DATA FORMAT – Concatenation
Concatenation disabled, 2 EAN/UPC codes concatenated, Set First
Concatenated Code Length 000 = any length, Set Second Concatenated
Code Length 000 = any length, Set Third Concatenated Code Length 000 =
any length, Set Fourth Concatenated Code Length 000 = any length,
Concatenation with Intercode Delay disabled, Concatenation Timeout 10
seconds, Concatenation Failure Transmission = Tx codes causing failure,
Transmission after Timeout = No code transmission, Concatenation Result
Code ID = No code Identifier
ADVANCED FORMATTING PARAMETERS
format disabled

CAMERA CONTROL

exposure mode = automatic, based on entire image
* The default values of these parameters are set when reading the interface
selection.
12

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Gryphon d432e

Inhaltsverzeichnis