First Start-Up - Datalogic Gryphon D432 Kurzanleitung

from the O.S. (if requested). When configuring the USB-COM interface, the
relevant files and drivers must be installed from the USB Device Installation
software, which
http://www.scanning.datalogic.com.
The reader is ready.
Green LED off
BEEP OK
Successive start-ups will automatically recognize the previously loaded drivers.
If external power is used, verify that external power is already supplied.
Connect external power supply to
BEEP OK
can be
Green LED blinks
Disconnect reader
at Host
Connect external
power supply to
cable and power up
Reconnect reader
cable to Host and
close dialog box
Successive Start-Ups
Green LED blinks
Disconnect reader at Host
cable and power up
Reconnect reader cable to
Host and close dialog box
downloaded

First Start-Up

Gryphon™ D432/D432E to Host
YES
warning that Bus
Select desired USB
(USB-KBD is default)
Read test codes.
Reader is READY
Connect Gryphon™ D432/D432E
YES
Does a dialog box
appear warning
that Bus power is
not sufficient?
Read test codes.
Reader is READY
GRYPHON™ D432/D432E
from the
Connect
Load drivers
(if requested)
Does a dialog
box appear
power is not
sufficient?
NO
Green LED off - BEEP OK
interface code
Load drivers
(if requested)
to Host
NO
Green LED off - BEEP OK
web site
7