Inhaltsverzeichnis
Werbung
1 DEFAULT
UK
Read the RESTORE DEFAULT.
Leggere il codice che ripristina i default.
I
Lecture du code de configuration par défaut.
F
Lesen Sie den Restore Default Code, um die
D
Werkseinstellung wieder herzustellen.
RS232 DEFAULT SETTINGS
9600 baud, no parity, 8 data bits, 1 stop bit, no handshaking,
delay disabled, rx timeout 5 sec., ack/nack disabled, fifo
enabled;
DATA FORMAT
code length not transmitted, no header, terminator = CR-LF,
character replacement disabled
WEDGE DEFAULT SETTINGS
USA keyboard, caps lock off, num lock unchanged, delays
disabled;
DATA FORMAT
code length not transmitted, no header, terminator = ENTER,
character replacement disabled
PEN EMULATION DEFAULT SETTINGS
interpret mode, conversion to code 39 disabled, output level
normal, idle level normal, minimum output pulse 600 µs,
overflow medium, inter-block delay disabled
POWER SAVE
scan rate 270 scans/s, standby disabled, sleep disabled
READING PARAMETERS
operating mode hand-held, hardware trigger, trigger active
level, no timeout, Flash On = 1 sec, Flash Off = .6 sec, one
read per cycle, safety time .5 sec, beeper intensity high,
tone 2, beeper type monotone, beeper length short, good
read spot duration medium
RESTORE DEFAULT
: code identifier disabled, no field adjustment,
: code identifier disabled, no field adjustment,
Werbung
Inhaltsverzeichnis
