ABB TZIDC-200 Betriebsanleitung Seite 58

Certificate No.:
Date of Issue:
Manufacturer:
Manufacturing location(s):
This certificate is issued as verification that a sample(s), representative of production, was assessed and tested and
found to comply with the IEC Standard list below and that the manufacture'rs quality system, relating to the Ex products
covered by this certificate, was assessed and found to comply with the IECEx Quality system requirements. This
certificate is granted subject to the conditions as set out in IECEx Scheme Rules, IECEx 02 and Operational Documents
as amended.
STANDARDS:
The electrical apparatus and any acceptable variations to it specified in the schedule of this certificate and the identified
documents, was found to comply with the following standards:
IEC 60079-0 : 2000
Edition: 3.1
IEC 60079-11 : 1999
Edition: 4
IEC 60079-15 : 2001
Edition: 2
This Certificate does not
TEST & ASSESSMENT REPORTS:
A sample(s) of the equipment listed has successfully met the examination and test requirements as recorded in
IECEx ATR:
DE/TUN/04/551542
58
IECEx TUN
2004-07-29
ABB Automation Products GmbH
Schillerstraße 72
32425 Minden
Germany
ABB
Automation Products GmbH
Schillerstraße 72
32425 Minden
Germany
Electrical apparatus for explosive gas atmospheres - Part 0: General requirements
Electrical apparatus for explosive gas atmospheres - Part 11: Intrinsic safety 'i'
Electrical apparatus for explosive gas atmospheres - Part 15: Type of protection 'n'
indicate compliance with electrical safety and performance requirements other than those
expressly included in the Standards listed above.
Elektropneumatischer Stellungsregler TZIDC-200
IECEx Certificate
of Conformity
04.0015X
File Reference:
04 YEX 551542
0
Issue No.:
2 4
Page of
42/18-80 DE