Cleaning The Filters In The Water Inlet; Cleaning Procedure; Wash-Card; Insert Wash-Card - Schulthess Spirit proLine WEI 9080 Bedienungsanleitung

Cleaning the filters in the water inlet

The filters in the water inlet must be cleaned if no water
or insufficient water flows into the appliance when the
tap is turned on. The error message «CHECK WATER
SUPPLY» is displayed.
The filters are located in the threaded hose coupling on
the water tap and at the back of the machine.

Cleaning procedure

1.
Turn the water tap off.
2.
Select a programme, start it and after approx. 20 seconds
select «Programme end» with the Quick Wash button.
As a result, the water pressure in the inlet hose can be
reduced.
3.
Unscrew the hose from the water tap and rinse out the
filter under running water.
4.
Connect the hose again.
5.
Unscrew the hose only from the back of the machine.
6.
Pull out filter using a pair of flat-nose pliers. Clean and
reinsert it.
7.
Connect the hose again.
8.
Turn the water tap on and make sure that no water
escapes.
9.
Turn the water tap off.
55

Wash-Card

Insert Wash-Card

Insert the WashCard holding the desired programmes
with the -symbol upwards. The wash programmes
stored on the card are shown on the display.
SXX = Special programmes Nos. 11÷20

Storing wash programmes

X The special programmes are stored by pressing the
button.
The message «WASHCARD STORED» appears.

Remove the Wash-Card

The Wash-Card is not required for washing.

Selecting special programmes

(see chapter «Special programmes»)
X After pressing the
10 possible Wash-Card programmes appears.
X Pressing the button again displays the remaining
Wash-Card programmes.

Additional functions

It is not possible to reduce the wash temperature or spin
speed on Wash-Card programmes.
It is not possible to activate the rinsing stop function by
deselection of the spin speed on Wash-Card programmes.
button 10 times, the first of