Cleaning The Filter In The Water Inlet; Cleaning Procedure - Schulthess Spirit topLine 7540i Bedienungsanleitung

Cleaning the filter in the water inlet

The filter in the water inlet must be cleaned if no water
or insufficient water flows into the machine when the tap
is turned on. The error message «CHECK WATER INLET
AND START» is displayed.
The filter are located in the threaded hose coupling on
the water tap and at the back of the machine.

Cleaning procedure

1.
Turn the water tap off.
2.
Select a programme, start it and after approx. 20 seconds
select «Programme end» with the Quick Wash button.
As a result, the water pressure in the inlet hose can be
reduced.
On machines without Aqua-Stop
3.
Switch off the mains power supply.
4.
Unscrew the hose from the water tap and rinse out the
filter under running water.
5.
Connect the hose again.
6.
Unscrew the hose only from the back of the machine.
7.
Pull out filter using a pair of flat-nose pliers. Clean and
reinsert it.
8.
Connect the hose again.
9.
Turn the water tap on and make sure that no water
escapes.
10.
Turn the water tap off.
52
On machines with Aqua-Stop
3.
Switch off the mains power supply
4.
Unscrew the hose only from the water tap.
5.
Pull out filter using a pair of flat-nose pliers. Clean and
reinsert it.
6.
Connect the hose again.
7.
Turn the water tap on and make sure that no water
escapes.
8.
Turn the water tap off.