Cleaning The Filter In The Water Inlet; Cleaning Procedure - Schulthess Spirit eMotion 7010 Bedienungsanleitung

5.
Close the maintenance hatch.
6.
Switch the mains power back on. Select a washing pro-
gramme and as soon as the water inlet stops, select pro-
gramme end with the fast run button.
This procedure prevents detergent from flowing unused
into the drainage system at the next wash.

Cleaning the filter in the water inlet

The filter in the water inlet must be cleaned if no water
or insufficient water flows into the appliance when the
tap is turned on. The error message «Check water inlet»
is displayed.
The filter are located in the threaded hose coupling on
the water tap and at the back of the machine.

Cleaning procedure

1.
Turn the water tap off.
2.
Select a programme, start it and after approx. 20 se-
conds select «Programme end» with the quick wash
button.
As a result, the water pressure in the inlet hose can be
reduced.
On machines without Water Stop
3.
Switch off the mains power supply.
4. Unscrew the hose from the water tap and rinse out the
filter under running water.
5.
Connect the hose again.
6. Unscrew the hose only from the back of the machine.
7.
Pull out filter using a pair of flat­nose pliers. Clean and
reinsert it.
48
8. Connect the hose again.
9.
Turn the water tap on and make sure that no water
escapes.
10. Turn the water tap off.
On machines with Water Stop
3.
Switch off the mains power supply.
4.
Unscrew the hose only from the water tap.
5.
Pull out filter using a pair of flat­nose pliers. Clean and
reinsert it.
6. Connect the hose again.
7. Turn the water tap on and make sure that no water
escapes.
8.
Turn the water tap off.