Operating The Hedge Trimmer; Swivelling Out The Blade Beam; Attach The Shoulder Strap - FLORABEST FHL 900 E5 Originalbetriebsanleitung

IE
GB
ting block (25). Insert the screws
(26), each together with a
washer (27), through the aligned
holes and screw the barrier
bracket using the Allen key (28)
supplied to the round handle
(13) until it lies flat against this.
Place the round handle (13) on
the tube. Fold on the counter-
holder (29) of the round handle
and screw it on together with the
large washer (30) with the rotary
knob (31).
The dismantling takes place in reverse order.
Make sure when mounting the round
handle (13) on the correct position of the
leg protection (14) for right-handed/vari-
ant a) or left-handed/variant b).
See Figure C .
Operating the Hedge
Trimmer
Do not use the equipment
without the hand guard.
Wear suitable clothing and
work gloves when working
with the equipment.
Ensure that the equipment
is functional before each
use. The On/Off switch and
the safety switch must not
be held closed. They must
switch off the motor when on
is released. Should a switch
be damaged, stop working
with the equipment. Ensure
that the mains voltage value
matches the label on the
equipment.
30
Note noise protection and local
specifications. The use of the equip-
ment on certain days (e.g. Sundays
and national holidays), at certain
times of day (lunch times, night time
quiet periods) or in special areas
(e.g. health resorts, clinics etc.) is
restricted or forbidden.
Swivelling Out the Blade
Beam
D
1. Hold the safety blade beam
( A 1) on the handle to adjust
the blade beam (5).
2. Unlock the safety lever (3) and
keep it pressed.
3. By simultaneously exerting pres-
sure on the lock lever (4), you
will loosen the fixation of the
cutter bar (
4. The safety blade beam (
can now be swivelled out. Use
the stop stages and allow the
stop lever (4) to click back in.
You can choose 9 stop stages.
5. Then, release the safety lever (3)
again and ensure that it latches
back into its initial position.

Attach the shoulder strap

Attach the shoulder strap spring clip
( A 20) to the carrying eyelet (
the tubular shank of the device. Set the
strap length such that the spring clip on the
shoulder strap is roughly at the height of
your hip.
1).
A
A 1)
A 21) on