Safety; Intended Use; Safety Standards - Zeversolar Evershine TL3680 Installationshandbuch

2 Safety

2.1 Intended use

2.1.1. Evershine converts the direct current from a PV array into grid-compliant
alternating current.
2.1.2. Evershine is suitable for indoor and outdoor use.
2.1.3. Evershine must only be operated with PV arrays (PV modules and cabling) of
protection class II, in accordance with IEC 61730, application class A.
Do not connect any sources of energy other than PV modules to the Evershine.
2.1.4. PV modules with a high capacitance to ground may only be used if their coupling
capacity does not exceed 1.0μF.
2.1.5. When the PV modules are exposed to sunlight, a DC voltage is supplied to this
equipment.
2.1.6. When designing the PV installation, ensure that the values comply with the
permitted operating range of all components at all times. The free design
program "Everplan"
(http://everplan.zeversolar.com) will assist you.

2.2 Safety standards

Evershine inverters comply with the EU Low Voltage Directive 2006/95/EC and the
EMC Directive 2004/108/EC. They are labeled with the CE mark and meet the
requirements specified in the following standards.
Type
Evershine TL3680
Evershine
TL5000-10
6
VDE 0126-1-1 (2013), VDE 0126-1-1/A1 (2012), G83/2 (2012), IEC
62116 (2008)
VDE-AR-N 4105 (2011), VDE 0126-1-1 (2013), VDE 0126-1-1/A1
(2012), G83/2 (2012), G59/3(2013), AS4777 (2005), NEN EN
50438, C10/11 (2012), UTEC 15-712-1 (2010), EN50438 (2007),
RD 1699 ( 2011), PPC, IEC 61727 (2004), AS/NZS 3100 (2009),
ÖVE/ÖNORM E 8001-4-712 (2009), IEC 62116 (2008)
Standards
Installation and Operating Instructions