Zeversolar Evershine TL3680 Installationshandbuch Seite 45

Set the safety standard as described below:
Step 1：Check whether the inverter is correctly connected to the PV module (without
AC connection), the LCD display shows the characters below:
Step 2：Press the control key (see section 9.1) every second until the LCD display
shows the characters below:
If you press the control key for ten seconds, the LCD display will show the safety
regulation information below:
DE VDE-AR-N 4105 stands for Germany safety regulation (VDE4105)
DE VDE-AR-N 4105
Step 3：Before the LCD backlight goes out from step 2, press the control key again
every second, and the safety regulation showing on the screen will constantly
change.
For example, if you select the safety regulation for the Netherlands, press the
control key every second until the LCD display shows "NL NEN50438":
If you stop operation, the LCD backlight will go out after approximately ten seconds.
The NL NEN50438 safety regulation setting is saved.
Note:
1. If the LCD display shows "DEFAULT", keep on pressing the key until the LCD display
shows the desired safety regulation.
44
Error Code: 35
Pac= 0.0w
TL××××
Pac= 0.0w
Pac= 0.0w
NL NEN50438
Pac= 0.0w
Installation and Operating Instructions