Zeversolar Evershine TL3680 Installationshandbuch Seite 47

Fault
The last five failure reports on the network and system protection device can be
read. An interruption in the supply voltage of ≤ 3 seconds does not result in any loss
of failure reports (as per VDE-AR-N 410
46
37 PV Over-voltage
36 Ground I Fault
4 DC INJ High
38 Isolation failure
DC feed-in. differs
44
for M-S
Ground
43
for M-S
Fac differs for M-S
42
Vac differs for M-S
41
Fac,Vac differs for
45
M-S
3 Relay-Check Fail
EEPROM
2
R/W Fail
1 SCI Failure
10 Device Fault
The voltage of the strings exceeds the
permitted upper limit.
The residual current exceeds the permitted
upper limit.
Output DC feed-in exceeds the permitted
upper limit.
The PV array's insulation resistance to
ground is below the permitted value or the
electrical insulation inside the inverter has
failed
A different value of DC feed-in has been
detected by master and slave MCU.
I differs A different value of residual current has
been detected by master and slave MCU.
A different value of grid frequency has
been detected by master and slave MCU.
A different value of grid voltage has been
detected by master and slave MCU.
A different value of grid frequency and
voltage has been detected by the master
and slave MCU.
The output relay has failed.
Reading or writing of EEPROM fails
Communication between the master and
slave CPU has failed.
Unknown error
Installation and Operating Instructions