Assembling The Dc Connectors - Zeversolar Evershine TL3680 Installationshandbuch

5.5.2 Assembling the DC connectors

Assemble the DC connectors as described below. Make sure to observe the correct
polarity. The DC connectors are marked with the symbols "+" and " − ".
Cable requirements：
The cable must be of type PV1-F，UL-ZKLA or USE2 and comply with the following
properties：
External diameter：5-8 mm

Conductor cross-section：2.5-6 mm²

Number of conductors：at least 7

Nominal voltage：at least 600V

Proceed as follows to assemble each DC connector.
1. Strip 12 mm of the cable insulation.
2. Route the stripped cable into the DC connector. Ensure that the stripped cable and
the DC connector have the same polarity.
Installation and Operating Instructions 27