Second Protective Grounding Connection - Zeversolar Evershine TL3680 Installationshandbuch

5.4.3 Second protective grounding connection

If required, the grounding terminal can be used to connect a second protective
conductor or as equipotential bonding.
Procedure
1. Remove the terminal lug, insert the stripped grounding conductor into the terminal
lug and crimp the contact.
2. Align the plain washer, the terminal lug with the grounding conductor, and the
ground washer on the screw. The teeth of the ground washer must be facing the heat
sink.
3. Insert the screw through the hole at the side of the heat sink, and tighten it firmly
into the wall bracket (torque: 2Nm).
Information on grounding components：
No. Description
1 Heat sink
Ground washer φ5
2
3 Terminal lug (M5) with protective conductor
4 Large plain washerφ6
5 M5×12 pan head screw
22 Installation and Operating Instructions