4.3 Mounting the inverter with the wall bracket
CAUTION!
Risk of injury due to the heavy weight of the inverter!
• When mounting, take into account that the inverter weighs approx. 19.5kg.
Mounting procedures:
1.
Use the wall bracket as a drilling template
and mark the positions of the drill holes, then
drill 4 holes (φ10) to a depth of 55~60mm.
During operation, keep the drill vertical to the
wall, and hold the drill steady to avoid tilted
holes. After cleaning the dust from the holes,
measure their net depth.
CAUTION!
Risk of injury if the inverter falls down
• Before inserting the screw anchors, measure the depth and distance of the holes.
• If the measured values do not meet the hole requirements, redrill the holes.
2.
After having drilled the holes in the wall, place four screw anchors into the holes,
then attach the wall mounting bracket to the wall using the supplied self-tapping
screws and washers.
14
Installation and Operating Instructions