Diseqc Tm Commands; Histogram Display - Kathrein MSK 115 Betriebsanleitung

DISEQC COMMANDS
TM
Requested satellite level:
Exit
SAT A_Ver_Low
SAT A_Ver_High
SAT A_Hor_Low
SAT A_Hor_High
SAT B_Ver_Low
SAT B_Ver_High
SAT B_Hor_Low
SAT B_Hor_High
SAT C_Ver_Low
SAT C_Ver_High
SAT C_Hor_Low
SAT C_Hor_High
SAT D_Ver_Low
SAT D_Ver_High
SAT D_Hor_Low
SAT D_Hor_High
ASTRA SCR
ASTRA SCR
ASTRA SCR
HOTBIRD SCR
HOTBIRD SCR
The hexadecimal DiSEqC
TM
They allow DiSEqC
Measurement on single cable systems: For switching on the SCR system carrier (in the measurement case
here 1400 MHz), fi rst select the single cable system to be measured from the DiSEqC
SCR 4SU* (i.e.: Astra single cable matrix system for 4 subscribers), then press the > button to send the
DiSEqC TM command to activate the SCR *1400 MHz * carrier. The ASTRA SCR measurement point can then
be selected in the satellite selection to evaluate the received signal.

HISTOGRAM DISPLAY

1)
"SCR" stands for Single Cable System
2)
„SU" stands for SubScriber
12
OPERATING MENU
LNB
1)
4SU
1) 2)
8SU
1) 2)
LNB
1)
8SU
1) 2)
TM
commands that are sent are standardised commands based on a 22 kHz grid.
TM
switches, DiSEqC matrices and respective single cable systems to be activated.
The MSK 115 has a histogram display. This can be used
in SCR single cable systems to measure up to 9 different
frequencies at the same time.
These frequencies are typically:
SCR1 = 1168 MHz
SCR2 = 1284 MHz
SCR3 = 1400 MHz
SCR4 = 1516 MHz
SCR5 = 1632 MHz
SCR6 = 1748 MHz
SCR7 = 1864 MHz
SCR8 = 1980 MHz
SCR9 = 2096 MHz
DiSEqC TM commands transmitted:
E0 10 38 F0
E0 10 38 F1
E0 10 38 F2
E0 10 38 F3
E0 10 38 F4
E0 10 38 F5
E0 10 38 F6
E0 10 38 F7
E0 10 38 F8
E0 10 38 F9
E0 10 38 FA
E0 10 38 FB
E0 10 38 FC
E0 10 38 FD
E0 10 38 FE
E0 10 38 FF
E0 10 5A 0D 99
E0 10 5A 0D 35
E0 10 5A 2D 53
E0 10 5A 09 5F
E0 10 5A 39 D0
TM menu, e.g. *ASTRA