Kathrein MSK 115 Betriebsanleitung Seite 35

OPERATING MENU
To call up the sub-menu from the search screen, press the
UP button. Use the cursor buttons to select from the various
options. The measuring instrument can be switched off at
any time. To do this, press and hold down the UP button.
Once "Exit" is highlighted, the RIGHT button can be used to
switch off the measuring instrument.
TM TM
The DiSEqC LNB function allows you to issue a DiSEqC
switching command. There are 16 SAT levels selectable for
this. As soon as a command has been selected, the instrument
automatically reverts to the search screen. To exit this screen
without triggering the command, you can scroll back and
highlight "Exit". A comprehensive explanation of the spectrum
and constellation menu can be found on pages 13 and 14 of this
operating manual.
The "Custom Carrier" mode is a new function which allows you
to defi ne your own carrier on to which you wish to lock on. This
can be very useful if you wish to optimise a specifi c service after
the satellite has been located. This function can also be used
for a "single cable system". This selection can also be saved
separately from your pre-defi ned selection. The comprehensive
explanation of the "Custom Carrier" mode can be found on page
15 onwards.
Pressing "Recall Custom" calls up the previously saved carrier
for measurement. Press the RIGHT button to select this carrier.
A comprehensive explanation of the "Recall Custom" mode can
be found on page 17.
The "Log as 000xx" function allows the most recent
measurement result to be saved under a sequential number. The
additional "Kathrein LOG reader" software allows these results to
be displayed in a table on the PC.
The "LNB/Cable test" function provides a test current to check
the cable resistance to the LNB. If this is too low or the cable is
open circuit, the message "LNB/Cable fault" appears.
11