Control Modes; Dmx-Describtion - Litecraft ZX. 6 Bedienungsanleitung

Control Modes

DMX-Describtion

display
ZX.6
V *.*
<Slave>
Auto
<******>
Static
<Dimmer>
BackLite
<***>
Info
Address
<***>
Channel
<****>
M&S Mode
<******>
Temp
<****>
20
function
ZX.6 shows the software version direct after switching on the unit
V *.* this messages appears after 3 seconds automaticly
*.* = software-version
Unit is in slave mode and is controlled by external values received by dmx-input
(this menu is only for information - no settings available)
Auto 8 pre-programmed chasers available
<********> (deactivation of all pre-programmed chasers by menu M&S Mode!)
******** =
<Auto 0>
<Auto 1>
<Auto 2>
<Auto 3>
<Auto 4>
<Auto 5>
<Auto 6>
<Auto 7>
Speed speed setting with 100 steps for the pre-programmed chaser available
<***>
*** = <1 - 100>
Dimmer manual control of brightness with 256 steps available
<***>
*** = <0 - 255>
Strobe manual control of fl ash rate with 256 steps available
<***>
*** = <0 - 255>
BackLite setting the automatic switch off for lcd backlite
<***> (permanent on, switch off after 10, 20, 30 seconds)
*** =
<On>
<10S>
<20S>
<30S>
Auto automatic test programm available
Test
FixHours display the fi xture hours
<****H>
**** = fi xture hours
Version display the software version
V*.*
*.* = software version
Address display the DMX-adress
<***> ( 1 Ch = <001-512>)
*** = DMX-adress ( 5 Ch = <001-508>)
( 6 Ch = <001-507>)
(10 Ch = <001-503>)
Channel choosing DMX-channel mode
**** = (description of modes in next chart)
< 1 Ch>
< 5 Ch>
< 6 Ch>
<10Ch>
M&S Mode choosing working mode
(Master = control without external controller)
<******>
****** = (Slave = control with external controller)
<Master>
<Slave>
Temp display the inside fi xture-temperature
<****>
**** = fi xture
temperature