E) Setting The Rudder Deflections - Reely Wild Hawk 1380197 Bedienungsanleitung

• Push the control lever for the motor function slowly from the bottom to the top position. The rotor will start up and
increase speed depending on control lever position.
• When the control lever is at the top stop, the maximum rotor speed is reached. Then move the control lever back to
the bottom-most position.
• Perform a brief engine test and check the run of the propeller and the propeller catch.
• Disconnect the flight battery from the model and switch off the transmitter.
e) Setting the Rudder Deflections
If the construction is performed and the transmitter set correctly, the rudders should have the following rudder deflec-
tion values:
Aileron
Elevator
Rudder
Attention!
The indicated values show the rudder deflections to be selected for the first flights.
Adjust the deflections to your personal preferences after a familiarisation period.
The enclosed remote control system does not permit setting of the servo paths at the transmitter and thus
the rudder deflections at the model as more expensive computer-based remote control systems do. To
change the rudder deflections, the desired values are set by repositioning the push rods on the servo arms
or the flaps.
12 mm upwards
12 mm upwards
25 mm to the left
Figure 17
12 mm downwards
12 mm downwards
25 mm to the right
61